Reference Guide

6
 700 g (1.54 lb)
2.1.1.2 Interfaces
The module provides the following network interfaces:
 5 x 10/100/1000 Base-T Ethernet (RJ45) ports
 1 x console interface (Disabled in FIPS mode by TEL)
 802.11a/b/g/n Antenna Interfaces (Internal)
 1 x USB 2.0 port
The module provides the following power interfaces:
 12V DC on RAP-155
 54V DC on RAP-155P
2.1.1.3 Indicator LEDs
There are 8 bicolor LEDs on the RAP-155, and 10 on the RAP-155P, which operate as follows:
Table 1 - RAP-155/155P Indicator LEDs
Label/Function Function Mode Status
PWR
Power On-Green Device Ready
Flashing-Green Device booting - not ready
Red Initial power-up condition
Off No power
Ports (E0, E1,
E2, E3, E4)
Ethernet Network
Link Status / Activity On-Green 1000 Mbps link established
Off No Ethernet link
On-Yellow 10/100 Mbps link established
Flashing Ethernet activity
RF0 (Radio 0,
5GHz, 802.11a/n)
5 GHz Radio Status On-Green
5GHz radio enabled in HT WLAN
mode
Flashing 5GHz Air monitor
On-Yellow
5GHz radio enabled in non-HT
WLAN mode
Off 5GHz radio disabled