Reference Guide

Aruba 3000, 6000/M3 Mobility Controller FIPS 140-2 Level 2 Security Policy|9
M3mk1-S-F1 M3mk1-S-F1 M3mk1-S-F1 LC-2G24FP-1
M3mk1-S-F1 M3mk1-S-F1 M3mk1-S-F1 M3mk1-S-F1
An”x” represents an empty slot.
 Status indicator LEDs indicate power state, status of the device, and link activity.
 PS1, PS2, and PS3 are for Power Supply modules. The number of power supplies required for the
system depends on the number of Line Cards installed, and whether to include redundancy for fault
tolerance (please refer to the Aruba 6000 Mobility Controller Installation Guide). It is Crypto Officer’s
responsibility to install the power supplies. The two available power supplies are:
 200 W Power Supply (HW-PSU-200)
 400 W Power Supply (HW-PSU-400)
When using more than one power supply, verify that they are all of the same type. Do not mix 200 W
and 400 W power supplies in the same chassis.

Aruba 3000 Series
The Aruba 3000-series Controller chassis is a 1U non-modular chassis.
Figure2‐Aruba3000‐seriesControllerChassis
Figure 2 shows the front of the Aruba 3000-series Controller, and illustrates the following:
 System indicator LEDs indicate power state and status of the device.
 Four Gigabit Ethernet ports provide network connectivity.
 Optional 1000Base-X fiber optic ports provide network connectivity.
 Serial Console port is for connecting to a local management console.