Reference Guide

 Allow 24 hours for the TEL adhesive seal to completely cure.

 Record the position and serial number of each applied TEL in a security log.

Once applied, the TELs included with the AP cannot be surreptitiously broken, removed or reapplied

without an obvious change in appearance:

Each TEL has a unique serial number to prevent replacement with similar label. To protect the device from

tampering, TELs should be applied by the Crypto Officer as pictured below:

3.2.2 AP-92 TEL Placement

This section displays all the TEL locations of the Aruba AP-92. The AP-92 requires a minimum of 3 TELs

to be applied as follows:

3.2.2.1 To detect access to restricted ports:

 Spanning the serial port

3.2.2.2 To detect opening of the chassis cover:

 Spanning the bottom and top chassis covers on the right side

 Spanning the bottom and top chassis covers on the left side

Following is the TEL placement for the AP-92:

Figure 1 - AP-92 TEL placement front view

Figure 2 - Aruba AP-92 TEL placement left view