Reference Guide

7
 12V DC power supply
2.1.1.3 Indicator LEDs
There are 5 bicolor (power, ENET and WLAN) LEDs which operate as follows:
Table 1- AP-92 Indicator LEDs
Label Function Action Status
PWR AP power / ready status Off No power to AP
Red Initial power-up condition
Flashing – Green Device booting, not ready
On – Green Device ready
ENET Ethernet Network Link
Status / Activity
Off Ethernet link unavailable
On – Amber 10/100Mbs Ethernet link
negotiated
On – Green 1000Mbs Ethernet link negotiated
Flashing Ethernet link activity
11b/g/n 2.4GHz Radio Status Off 2.4GHz radio disabled
On – Amber 2.4GHz radio enabled in WLAN
mode
On – Green 2.4GHz radio enabled in 802.11n
mode
Flashing - Green 2.4GHz Air monitor or RF protect
sensor
11a/n 5GHz Radio Status Off 5GHz radio disabled
On - Amber 5GHz radio enabled in WLAN
mode
On – Green 5GHz radio enabled in 802.11n
mode
Flashing - Green 5GHz Air monitor or RF protect
sensor
2.2 AP-93
This section introduces the Aruba AP-93 Wireless Access Point (AP) with FIPS 140-2 Level 2 validation.
It describes the purpose of the AP, its physical attributes, and its interfaces.
The Aruba AP-93 is a high-performance 802.11n (2x2:2) MIMO, single-radio 2.4 GHz or 5 GHz (802.11a/
b/g/n) indoor wireless access point capable of delivering combined wireless data rates of up to 300Mbps.
This multi-function access point provides wireless LAN access, air monitoring, and wireless intrusion
detection and prevention over the 2.4-2.5GHz and 5GHz RF spectrum. The access points work in