Users Guide

891 | show aaa state debug-statistics Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
non-ip
Number of non-IP type packets sent between the datapath and the
controlpath.
zero-ip
Number of packets sent without an internet protocol (IP).
loopback
If 1, the controller has a defined loopback address. If 0, a loopback address
has not yet been configured.
mac mismatch
Number of users that were not authenticated due to MAC mismatches.
spoof
Number of users that were not authenticated due to spoofed IP addresses.
drop
Number of user authentication attempts that were dropped.
ncfg
Number of packets sent between datapath and controlpath, where the
authentication module has not completed the initialization required to
process the traffic.
Non-auth opcode
Number of packets whose opcode is non-auth opcode. This is a check to find if
auth is responsible for processing received packet.
No-l2-user
Number of user packets dropped due to absence ofan L2 entry for the user.
l2tp
Number of l2tp users.
vrrp
Number of VRRP users.
special mac
Number of users with a special MAC address.
iap
Number of instant AP users.
idled users Number of inactive stations that are not broadcasting data to an AP.
idled users due to MAC
mismatch
For internal use only.
Idled users due to SOS
wireless tunnel
Number of wireless users in tunnel forwarding mode that were aged out by the
controller.
wireless dtunnel
Number of wireless users in decrypt tunnel forwarding mode that were aged out
by the controller.
wired tunnel
Number of wired users in tunnel forwarding mode that were aged out by the con-
troller.
wired dtunnel
Number of wired users in decrypt tunnel forwarding mode that were aged out by
the controller.
Other
Number of users using modes other than tunneled or Decrypt tunneled aged out
by the controller.