Users Guide

865 | show aaa load-balance statistics Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
secret or bad reply digest.
Acc
Access accept. Number of responses from the RADIUS server with invalid secret
or bad reply digest.
Rej
Access reject. Number of responses from the RADIUS server that indicate that cli-
ent authentication failed.
Acct Rsp
Accounting response. Number of responses sent from the RADIUS server in
response to accounting requests sent from the controller.
Chal
Access challenge. Number of responses from the RADIUS server containing a
challenge for the client (to complete authentication).
Ukn Rsp
Unknown Response code. Number of responses from the RADIUS server that
were not understood by the controller due to the purpose or type of the response
Tmout
Timeouts. Number of messages sent by the controller for which the controller did
not receive a response before the message timed out.
NOTE: Timeouts include RADIUS accounting requests. Every request controller
sends to the RADIUS server is monitored for a timeout, so each retry
increments this counter.
AvgRspTme
Average response time. Time taken, on an average, for the RADIUS server to
respond to a message from the controller.
Tot Rq
Total errors. This counter reflects the total number of requests sent to the RADIUS
server (auth and accounting requests).
Tot Rsp
This counter reflects the total number of responses received by the RADIUS
server (auth and accounting responses).
Rd Err
Read errors. This counter reflects the total number of errors encountered while
reading off socket corresponding to that RADIUS server.
Uptime
Amount of for which the RADIUS server has been active/up. The RADIUS server
is considered to have an UP status if the server is active and serving requests.
The RADIUS server is considered to be DOWN if the server is not responding.
For example, if the RADIUS server does not respond for (<no of retries> *<
timeout>) seconds, the controller takes the RADIUS server down. It brings the
radius server back into service after the dead timeout.
SEQ
Information corresponding to the sequence number of requests. SEQ total cor-
responds to the total number of sequence numbers that can be used to com-
municate with the RADIUS server. SEQ free corresponds to the free/available/not
in use sequence numbers for a particular RADIUS server.
Outstanding Auths
This value keeps track of the number of clients that are currently getting authen-
ticated against this authentication server, i.e. clients for which the controller has
sent Access-Request but has not yet received Access-Accept or Access-Reject
and also the Access-Request has not timed out completely.