Users Guide

849 | show aaa authentication-server radius Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
Tot Rq
Total errors. This counter reflects the total number of requests sent to the
RADIUS server (auth and accounting requests).
Tot Rsp
This counter reflects the total number of responses received by the RADIUS
server (auth and accounting responses).
Rd Err
Read errors. This counter reflects the total number of errors encountered
while reading off socket corresponding to that RADIUS server.
Uptime
Amount of for which the RADIUS server has been active/up. The RADIUS
server is considered to have an UP status if the server is active and serving
requests. The RADIUS server is considered to be DOWN if the server is not
responding. For example, if the RADIUS server does not respond for (<no of
retries> *< timeout>) seconds, the controller takes the RADIUS server down.
It brings the radius server back into service after the dead timeout.
SEQ
Information corresponding to the sequence number of requests. SEQ total
corresponds to the total number of sequence numbers that can be used to
communicate with the RADIUS server. SEQ free corresponds to the
free/available/not in use sequence numbers for a particular RADIUS server.
(host) #show aaa authentication-server radius <servername> dsec radsec status
Radius Server "radsec" Radsec Status
------------------------------------
Radsec Server Attribute Value
----------------------- -----
In Service Yes
Connected Sockets 1
The output of this command includes the following information:
Parameter Description
In Service
Shows the status of the Radsec RADIUS server.
Connected Sockets
Shows the number of TLS connections with the RADIUS server.
Command History
Version Description
ArubaOS 3.0 Command introduced.
ArubaOS 6.1 The Source Interface parameter was introduced.
ArubaOS 6.3 The enable-ipv6 and nas-ip6 fields were added to the output of this
command.