Users Guide

773 | rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description Range Default
spectrum-profile <profile>
Specify the rf spectrum profile
used by hybrid APs and spectrum
monitors. This profile sets the
spectrum band and device
ageout times used by a spectrum
monitor or hybrid AP radio. For
details, see rf spectrum-profile on
page 784.
— default
tpc-power
The transmit power advertised in
the TPC IE of beacons and probe
responses. Range: 0-51 dBm
0-51 dBm 15 dBm
tx-power
Sets the initial transmit power
(dBm) on which the AP operates,
unless a better choice is available
through calibration.
This parameter can be set from 0
to 51 in .5 dBm increments, or set
to the regulatory maximum value
of 127 dBm.
Transmission power may be
further limited by regulatory
domain constraints and AP
capabilities.
0-51 dBm,
127 dBm
14 dBm
very-high-throughput-rates-
enable
This feature enables Very High
Throughput (VHT) rates on the
2.4 GHz band, providing 256-
QAM modulation and encoding
that allows for 600 Mbit/sec
performance over 802.11n
networks. Maximum data rates
are increased on the 2.4 GHz
band through the addition of VHT
Modulation and Coding Scheme
(MCS) values 8 and 9, which
support the highly efficient
modulation rates in 256-QAM.
Starting with ArubaOS 6.4.2.0,
VHT is supported on W-AP220
Series access points on both 20
and 40 MHz channels.
Using the controller’s CLI or
WebUI, VHT MCS values 0-9 are
enabled, overriding the existing
high-throughput (HT) MCS values
0-7, which have a lower
maximum data rate. However,
this feature should be disabled if
individual rate selection is
required.
— disabled
Usage Guidelines
This command configures radios that operate in the 2.4 GHz frequency band, which includes radios utilizing
the IEEE 802.11b/g or IEEE 802.11n standard. Channels must be valid for the country configured in the AP