Users Guide

767 | rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description Range Default
channel-reuse
When you enable the channel
reuse feature, it can operate in
either of the following three
modes; static, dynamic or disable.
(This feature is disabled by
default.)
l Static mode: This mode of
operation is a coverage-based
adaptation of the Clear
Channel Assessment (CCA)
thresholds. In the static mode
of operation, the CCA is
adjusted according to the
configured transmission
power level on the AP, so as
the AP transmit power
decreases as the CCA
threshold increases, and vice
versa.
l Dynamic mode: In this mode,
the Clear Channel
Assessment (CCA) thresholds
are based on channel loads,
and take into account the
location of the associated
clients. When you set the
Channel Reuse This feature is
automatically enabled when
the wireless medium around
the AP is busy greater than
half the time. When this mode
is enabled, the CCA threshold
adjusts to accommodate
transmissions between the AP
its most distant associated
client.
l Disable mode: This mode
does not support the tuning of
the CCA Detect Threshold.
enabled
disabled
enabled
channel-reuse-threshold
RX Sensitivity Tuning Based
Channel Reuse Threshold, in -
dBm.
If the Rx Sensitivity Tuning Based
Channel reuse feature is set to
static mode, this parameter
manually sets the AP’s Rx
sensitivity threshold (in -dBm).
The AP will filter out and ignore
weak signals that are below the
channel threshold signal
strength.
If the value is set to zero, the
feature will automatically
determine an appropriate
threshold.
depends on
regulatory
domain
—