Users Guide

743 | rf arm-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description Range Default
cm-stale-age <secs>
The controller maintains client match
data for up to clients showing the
detected SNRvalues for up to 16
candidate APs per client. This table is
periodically updated as APs send
client probe reports to the controller.
This parameter defines the amount
of time that the controller should
retain client match data from each
client probe report.
Different controller types support
varying numbers of clients.
l W-650 : 4096 clients
l W-3000 Series: 4096 clients
l W-7005: 1024 client
l W-7010: 2048 clients
l W-7030: 4096 clients
l W-7240: 32000 clients
l W-7220: 24000 clients
l W-7210: 16000 clients
l W-6000M3 = 8000 clients
0- 65535
seconds
900 secs
cm-steer-timeout
When a client is steered from one AP
to a more desirable AP, the steer
timeout feature helps facilitate the
move by defining the amount of time
that any APs to which the client
should NOT associate will not
respond to the AP.
0-255 secs
cm-sticky-check-interval
<secs>
Frequency at which the AP checks for
client's received SNR values. If the
SNR value drops below the threshold
defined by the cm-sticky-snr
parameter for three consecutive
check intervals, that clientmay be
moved to an different AP.
0-255 secs 3 secs
cm-sticky-min-signal
<-dB>
A client triggered to move to a
different AP may consider an AP
radio a better match if the client
detects that the signal from the
candidate AP radio is at or higher
than the minimum signal level
defined by this parameterand the
candidate radio has a higher signal
strength than the radio to which the
client is currently associated. (The
required improvement in signal
strength can be defined using the
cm-sticky-snr-delta command.)
0-255 (-dB) 65