Users Guide

739 | rf arm-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Syntax
Parameter Description Range Default
<profile>
Name of this instance of the profile.
The name must be 1-63 characters.
— “default”
40MHz-allowed- bands
The specified setting allows ARM to
determine if 40 MHz mode of
operation is allowed on the 5 GHz or
2.4 GHz frequency band only, on both
frequency bands, or on neither
frequency band.
All/None/
a-only/g-only
a-only
All
Allows 40 MHz channels on both the
5 GHZ (802.11a) and 2.4 GHZ
(802.11b/g) frequency bands.
— —
None
Disallows use of 40 MHz channels. — —
a-only
Allows use of 40 MHz channels on the
5 GHZ (802.11a) frequency band only.
— —
g-only
Allows use of 40 MHz channels on the
2.4 GHZ (802.11b/g) frequency band
only.
— —
80MHz-support
If enabled, 80 MHz channels can be
used in the 5 GHz frequency band on
APs that support 802.11ac.
— enabled
acceptable-coverage-index
The minimal coverage that the AP
should try to achieve on its channel.
The denser the AP deployment, the
lower this value should be.
This setting applies to multi-band
implementations only.
1-6 4
active-scan
When active-scan is enabled, an AP
initiates active scanning via probe
request. This option elicits more
information from nearby APs, but
also creates additional management
traffic on the network. This feature is
disabled by default, and should not be
enabled except under the direct
supervision of Dell Technical Support.
Default: disabled
— disabled
aggressive-scan
When this feature is enabled, an AP
radio with no clients will scan
channels every second.
— enabled