Users Guide

Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for the mesh parameters, additional antenna
parameters, and AP location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l installation
l mesh-sae
l set-ikepsk-by-addr
l usb-dev
l usb-dial
l usb-init
l usb-passwd
l usb-tty
l usb-type
l usb-user
l link-priority-cellular
l link-priority-ethernet
ArubaOS 5.0 The mesh-sae parameter no longer has the sae-default option. Use the
sae-disable option to return this parameter to its default disabled setting.
ArubaOS 6.0 The uplink-vlan parameter was introduced.
ArubaOS 6.1 The following new parameters were introduced for provisioning IPv6 APs:
l dns-server-ip6
l ip6addr
l ip6prefix
l gateway6
ArubaOS 6.2 The following new parameters provision APs in single-chain mode:
l sch-mode-radio-0
l sch-mode-radio-1
The following new parameters provision APs for 802.1X authentication:
l apdot1x-passwd
l apdot1x-username
The following new parameters provision Remote APs using USB modems:
l usb-modeswitch
Dell Networking W-Series ArubaOS 6.4.x | User Guide provision-ap | 726