Users Guide

ip ospf
ip ospf area|{authentication message-digest | cost <cost> | dead-interval <seconds> | hello-
interval <seconds> | message-digest-key <keyid> <passwd> | priority <number> | retransmit-
interval <seconds> |transmit-delay <seconds>
Description
Configure OSPF on the VLAN interface.
Syntax
Parameter Description Range Default
area
Enable OSPF on a specific
interface by entering the IP
address of the router that will
use OSPF.
authentication message-digest
Set the OSPF authentication
mode to message digest.
disabled
cost <cost>
Set the cost associated with the
OSPF traffic on an interface.
1 to
65535
1
dead-interval <seconds>
Set the elapse interval
(seconds) since the last hello-
packet was received from the
router. After the interval
elapses, the neighboring
routers declare the router
dead.
1 to
65535
seconds
40
hello-interval <seconds>
Set the elapse interval
(seconds) between hello
packets sent on the interface.
1 to
65535
seconds
10
message-digest-key <keyid> <passwd>
Enable OSPF MD5
authentication and set the key
identification and a character
string password.
<keyid> =
1 to 256
No default
priority <number>
Set the priority number of the
interface to determine the DR.
0 to 255 1
retransmit-interval <seconds>
Set the retransmission time
between link state
advertisements for adjacencies
belonging to the interface.
NOTE: Set the time interval long
enough to prevent unnecessary
retransmissions.
1 to
65535
seconds
5
Dell Networking W-Series ArubaOS 6.4.x | User Guide ip ospf | 542