Users Guide

Parameter
Description Range Default
priority-map
Applies a priority map to the interface.
Use the priority-map command to
configure a priority map which allows
you to map ToS and CoS values into high
priority traffic queues.
— —
shutdown
Causes a hard shutdown of the
interface.
— —
spanning-tree
Enables Rapid spanning tree or Per-
VLAN spanning tree.
— enabled
bpduguard
Enables bpduguard on the edge ports. — disabled
cost
Administrative cost associated with the
spanning tree.
1-65535 19 (Fast
Ethernet)
4 (Gigabit
Ethernet)
point-to-point
Set interface as point to point. — disabled
port-priority
Spanning tree priority of the interface. A
lower setting brings the port closer to
root port position (favorable for
forwarding traffic) than does a higher
setting. This is useful if ports may
contend for root position if they are
connected to an identical bridge.
0-255 128
portfast
Enables forwarding of traffic from the
interface.
— disabled
vlan
Configure the vlan instance. 1-4094 disabled
speed
Sets the interface speed: 10 Mbps, 100
Mbps, or auto configuration.
10|100|au
to
auto
switchport
Sets switching mode parameters for the
interface.
— —
access vlan
Sets the interface as an access port for
the specified VLAN. The interface carries
traffic only for the specified VLAN.
— 1
mode
Sets the mode of the interface to access
or trunk mode only.
access|tru
nk
access
Dell Networking W-Series ArubaOS 6.4.x | User Guide interface fastethernet | gigabitethernet | 468