Users Guide

Parameter
Description Range Default
<name>
Name of a bandwidth contract
configured with the aaa bandwidth-
contract command. If you specify a
bandwidth contract name before you
specify an application or application
category, the bandwidth contract is
applied to all downstream or upstream
traffic.
app <name>
Name of the application to which the
bandwidth contract is applied. For a
complete list of supported applications,
issue the command show dpi
application all.
— —
appcategory <name>
Name of the application category to
which the bandwidth contract is applied.
For a complete list of supported
applications, issue the command show
dpi application category all.
— —
downstream
Apply the bandwidth contract to
downstream traffic.
— —
upstream
Apply the bandwidth contract to
upstream traffic.
— —
exclude
<app>|<appcategory>
Use this parameter to exclude
application or application category
traffic from a bandwdth contract.
description
String that describes this interface. — —
duplex
Transmission mode on the interface: full
or half-duplex or auto to automatically
adjust transmission.
auto/full/ha
lf
auto
ip access-group
Applies the specified access control list
(ACL) to the interface. Use the ip
access-list command to configure an
ACL.
NOTE: This parameter requires the
PEFNG license.
— —
in
Applies ACL to interface’s inbound
traffic.
— —
out
Applies ACL to interface’s outbound
traffic.
— —
Dell Networking W-Series ArubaOS 6.4.x | User Guide interface fastethernet | gigabitethernet | 466