Users Guide

465 | interface fastethernet | gigabitethernet Dell Networking W-Series ArubaOS 6.4.x| User Guide
interface fastethernet | gigabitethernet
interface
interface {fastethernet|gigabitethernet} <slot>/<module>/<port>
bandwidth-contract <name>|{{app <app-name>|appcategory <app-category-name>} <bw-contract-
name>} upstream|downstream [exclude]
description <string>
duplex {auto|full|half}
ip access-group <name> {in|out|session {vlan <vlanId>}}
jumbo
lacp {group|port-priority|timeout}
lldp {fast-transmit-counter <1-8>|fast-transmit-interval <1-
3600>|med|receive|transmit|transmit-hold <1-100>|transmit-interval <1-3600> }600>
no ...
port monitor {fastethernet|gigabitethernet} <slot>/<port>
priority-map <name>
shutdown
spanning-tree {[bpduguard]|[cost <value>]|[point-to-point]|[port-priority <value>]|
[portfast] [vlan]}
speed {10|100|auto}
switchport {access vlan <vlan>|mode {access|trunk}|
trunk {allowed vlan {<vlans>|add <vlans>|all|except <vlans>|remove <vlans>}|
native vlan <vlan>}}
trusted {vlan <word>}
tunneled-node-port
xsec {point-to-point <macaddr> <key> allowed vlan <vlans> [<mtu>]|vlan <vlan>}
Description
This command configures a FastEthernet or GigabitEthernet interface on the controller.
Syntax
Parameter
Description Range Default
<slot>
<slot> is always 1. — —
<module>
<slot>/<module>/<port> (7000 Series
only)
<port>
Number assigned to the network
interface embedded in the
controller.Port numbers start at 0 from
the left-most position.
— —
bandwidth-contract
Apply a bandwidth contract to all
upstream of downstream traffic, or to
traffic for a specified application or
application category
NOTE: This feature is only supported on
W-7000 Series and W-7200 Series
controllers
— —