Users Guide

Parameter Description Range Default
disable-stateful-sips-processing
Configure the controller to
read SIP signaling messages
sent by Lync clients on port
5061.
— enabled
disable-stateful-ua-processing
Disables stateful UA
processing.
— disable
d
disable-stateful-vocera-processing
Disables stateful VOCERA
processing.
— disable
d
dpi
Enables Deep-Packet
Inspection (DPI)
— disable
d
drop-ip-fragments
When enabled, all IP fragments
are dropped. You should not
enable this option unless
instructed to do so by a Dell
representative.
— disable
d
enable-bridging
Enables bridging when the
controller is in factory default.
— disable
d
enable-per-packet-logging
Enables logging of every
packet if logging is enabled for
the corresponding session
rule. Normally, one event is
logged per session. If you
enable this option, each packet
in the session is logged. You
should not enable this option
unless instructed to do so by a
Dell representative, as doing
so may create unnecessary
overhead on the controller.
— disable
d
enforce-tcp-handshake
Prevents data from passing
between two clients until the
three-way TCP handshake has
been performed. This option
should be disabled when you
have mobile clients on the
network as enabling this option
will cause mobility to fail. You
can enable this option if there
are no mobile clients on the
network.
— disable
d
enforce-tcp-sequence
Enforces the TCP sequence
numbers for all packets.
— disable
d
Dell Networking W-Series ArubaOS 6.4.x | User Guide firewall | 392