Users Guide

391 | firewall Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description Range Default
deny-inter-user-bridging
Prevents the forwarding of
Layer2 traffic between wired or
wireless users. You can
configure user role policies
that prevent Layer3 traffic
between users or networks but
this does not block Layer2
traffic. This option can be used
to prevent traffic, such as
Appletalk or IPX from being
forwarded. If enabled, traffic
(all non-IP traffic) to untrusted
port or tunnel is also blocked.
— disable
d
deny-inter-user-traffic
Denies downstream traffic
between users in a wireless
network (untrusted users) by
disallowing layer2 and layer3
traffic. This parameter does
not depend on the deny-inter-
user-bridging parameter
being enabled or disabled.
— disable
d
deny-source-routing
Disallows forwarding of IP frames
with source routing with the
source routing options set.
— disabled
disable-ftp-server
Disables the FTP server on the
controller. Enabling this option
prevents FTP transfers.
Enabling this option could
cause APs to not boot up. You
should not enable this option
unless instructed to do so by a
Dell representative.
— disable
d
disable-stateful-h323-
processing
Disables stateful H.323
processing.
— disable
d
disable-stateful-sccp-processing
Disables SCCP processing. — disable
d
disable-stateful-sip-processing
Disables monitoring of
exchanges between a voice
over IP or voice over WLAN
device and a SIP server. This
option should be enabled only
when there is no VoIP or
VoWLAN traffic on the network.
— disable
d