Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series Controller AOS
12345678910
Dell Networking W-Series ArubaOS 6.4.x| User Guide The ArubaOS Command-Line Interface | 3
The ArubaOS Command-Line Interface
The Dell Networking W-Series ArubaOS 6.4.x command-line interface (CLI) allows you to configure and manage
Dell controllers. The CLI is accessible from a local console connected to the serial port on the controllers or
through a Telnet or Secure Shell (SSH) session from a remote management console or workstation.
Telnet access is disabled by default. To enable Telnet access, enter the telnet CLI command from a serial connection
or an SSH session, or in the WebUI navigate to the Configuration > Management > General page.
What's New In ArubaOS 6.4.x
This section lists the commands introduced, modified, or deprecated in ArubaOS 6.4.x.
Commands in ArubaOS 6.4.3.0
New Commands
The following commands are introduced in ArubaOS 6.4.3.0:
Command Description
aaa auth-survivability This command configures authentication survivability on a controller.
amon msg-buffer-size This command modifies the AMON packet size on the controller.
clear aaa auth-survivability-
cache
This command, introduced with this release, allows you to clear the
data stored in the local Survival Server cache
crypto_local isakmp disable-
ipcomp
This command disables IP compression on the master controller.
disable-whitelist-sync This command disables whitelist synchronization with local or Cloud
Services Controller on the master controller.
ip access-list route This command configures an access control list (ACL) for policy-based
packet routing.
ip nexthop-list A next hop IP is the IP address of an adjacent router or device with
layer-2 connectivity to the controller. Use this command to configure
a next hop list, providing redundancy for the next hop devices by
forwarding the traffic to a backup next hop device in case of failures.
ip probe This command configures WAN health-check ping-probes for
measuring WAN availability and latency.
pan-options This command configures options to integrate a branch controller
with a Palo Alto Networks (PAN) firewall