Users Guide

cfgm
cfgm {set config-chunk <kbytes>|set heartbeat <seconds>|set maximum-updates <number>|snapshot-
timer <minutes>|sync-command-blocks <number>|sync-typecomplete|sync-type snapshot}
Description
This command configures the configuration module on the master controller.
Syntax
Parameter Description Range Default
set config-chunk
Maximum packet size, in Kilobytes, that is
sent every second to the local controller
whenever the master controller sends a
configuration to the local. If the connection
between the master and local is slow or
uneven, you can lower the size to reduce the
amount of data that needs to be
retransmitted. If the connection is very fast
and stable, you can increase the size to make
the transmission more efficient.
1-100 10 Kbytes
set heartbeat
Interval, in seconds, at which heartbeats are
sent. You can increase the interval to reduce
traffic load.
10-300 10 seconds
set maximum-updates
Maximum number of local controllers that
can be updated at the same time with
configuration changes. You can decrease this
value if you have a busy network. You can
increase this value to improve configuration
synchronization.
2-25 5
snapshot-timer
Interval, in minutes, that the local controller
waits for a configuration download from the
master upon bootup or startup before loading
the last snapshot configuration.
5-60 5 minutes
sync-command-blocks
To configure the number of command-list
blocks. Each block contains a list of global
configuration commands for each write-mem
operation.
3-10 5
sync-type complete
The master sends full configuration file to the
local.
— —
sync-type snapshot
The master sends only the incremental con-
figuration to the local.
NOTE: By default, this configuration is enabled.
— Enable
Dell Networking W-Series ArubaOS 6.4.x | User Guide cfgm | 278