Users Guide

Parameter Description
Certain cellular devices must be modeswitched
before the modem switches to data mode.
no
Enter the keyword no to negate the command and
revert back to the defaults.
priority <1-255>
Enter the keyword priority to override the default
cellular priority (100).
Range: 1 to 255.
Default: 100
serial <sernum>
Enter the keyword serial followed by the USB device
serial number
tty <ttyport>
Enter the keyword tty followed by the Modem TTY
port (i.e. ttyUSB0, ttyACM0)
user <login> password <password>
Enter the keyword user followed by your login, and
then enter the keyword password followed by your
password to establish user name authentication.
vendor <vend_id> product <prod_id> in hex
Enter the keyword vendor followed by the vendor ID
in hexadecimal (see show usb on page 1955) and
then enter the keyword product followed by the
product ID listed in the show usb command.
Usage Guidelines
The cellular modems are plug-and-play and support most native USB modems. Cellular modems are activated
only if it is the uplink with the highest priority (see show uplink on page 1954). However, new profiles can be
created using this command to support new data cards or to customize card characteristics.
Command History
Introduced in ArubaOS 3.4.
Command Information
Platforms Licensing Command Mode
W-600 Seriescontrollers Base operating system Config mode on master and local
controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide cellular profile | 276