Users Guide

Parameter Description Range Default
dot11a-traffic-mgmt-profile
Configures bandwidth allocation. See
wlan traffic-management-profile on page
2334.
— —
dot11g-radio-profile
Configures 802.11g radio settings and
load balancing for the AP group; contains
the ARM profile. See rf dot11a-radio-
profile on page 752.
— “default”
dot11g-traffic-mgmt-profile
Configures bandwidth allocation. See
wlan traffic-management-profile on page
2334.
— —
enet0-port-profile
Configures the duplex and speed of the
Ethernet interface 0 on the AP. For
information on how these profiles are
defined, see ap wired-port-profile on
page 241.
— “default”
enet1-port-profile
Configures the duplex and speed of the
Ethernet interface 1 on the AP. For
information on how these profiles are
defined, see ap wired-port-profile on
page 241.
— “default”
enet2-port-profile
Configures the duplex and speed of an
Ethernet interface 2 on the AP. These
profiles are defined using the command
ap wired-port-profile on page 241.
— “default”
enet3-port-profile
Configures the duplex and speed of an
Ethernet interface 3 on the AP. These
profiles are defined using the command
ap wired-port-profile on page 241.
— “default”
enet4-port-profile
Configures the duplex and speed of an
Ethernet 4 interface on the AP. For
information on how these profiles are
defined, see ap wired-port-profile on
page 241.
— “default”
event-thresholds-profile
Configures Received Signal Strength
Indication (RSSI) metrics. See rf event-
thresholds-profile on page 776.
— “default”
ids-profile
Configures Dell’s Intrusion Detection
System (IDS). See ids profile on page 439.
— “default”
Dell Networking W-Series ArubaOS 6.4.x | User Guide ap-group | 250