Users Guide

Parameter Description Range Default
and responses, and
process all 802.11e and
802.11k action frames.
NOTE: Virtual APs in bridge
or split-tunnel mode using
static WEP should use key
slots 2-4 on the controller.
Key slot 1 should only be
used with Virtual APs in
tunnel mode.
ha-disc-onassoc
If enabled, home agent
discovery is triggered on
client association instead of
home agent discovery
based on traffic from client.
Mobility on association can
speed up roaming and
improve connectivity for
clients that do not send
many uplink packets to
trigger mobility (VoIP
clients). Best practices is to
leave this parameter
disabled, as it increases IP
mobility control traffic
between controllers in the
same mobility domain.
Enable this parameter only
when voice issues are
observed in VoIP clients.
NOTE: ha-disc-onassoc
parameter works only when
IP mobility is enabled and
configured on the controller.
— disabled
hs2-profile
Enables or disables a
hotspot profile. This is
enabled by default.
— enabled
mobile-ip
Enables or disables IP
mobility on a virtual AP.
This is enabled by default.
L3 mobility service is active
on a VAP only if router
mobile is also enabled on
the controller.
— enabled
Dell Networking W-Series ArubaOS 6.4.x | User Guide wlan virtual-ap | 2348