Users Guide

Description Range Default
PEFNG license. Configure this
parameter only under the guidance of
your Dell representative.
ap|sta
Assigns the specified EDCA profile to
AP or station (client).
— —
enforce-user-vlan
Strict enforcement of data traffic only in
user's assigned vlan (Open stations
only).
— —
essid
Name that uniquely identifies a
wireless network. The ESSID can be up
to 31 characters. If the ESSID includes
spaces, you must enclose it in
quotation marks.
— aruba-ap
g-basic-rates
List of supported 802.11b/g rates that
are advertised in beacon frames and
probe responses.
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48, 54
Mbps
1, 2 Mbps
g-beacon-rate
Sets the beacon rate for 802.11g (use
for Distributed Antenna System (DAS)
only). Using this parameter in normal
operation may cause connectivity
problems.
default,
1,2,5, 6 9, 11,
12, 18, 24,
36, 48, 54
Mbps
minimum
valid rate
g-tx-rates
Set of 802.11b/g rates at which the AP
is allowed to send data. The actual
transmit rate depends on what the
client is able to handle, based on
information sent at the time of
association and on the current
error/loss rate of the client.
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48, 54
Mbps
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54 Mbps
hide-ssid
Enables or disables hiding of the SSID
name in beacon frames. Note that
hiding the SSID does very little to
increase security.
— disabled
ht-ssid-profile
Name of high-throughput SSID profile
to use for configuring high-throughput
support. See wlan ht-ssid-profile on
page 2314.
— “default”
local-probe-req-thresh
APs will not respond to client probe
requests if the SNR value in the probe
request is less than the specified
threshold value.
0-100 0
max-clients
Maximum number of wireless clients
for the AP.
0-256 64
Dell Networking W-Series ArubaOS 6.4.x | User Guide wlan ssid-profile | 2326