Users Guide

Parameter Description Range Default
This setting is useful when
deploying, maintaining, or
upgrading the network.
If enabled, APs stop flooding
unnecessary traps and syslog
messages to network
management systems or
network operations centers
when deploying, maintaining,
or upgrading the network. The
controller still generates debug
syslog messages if debug
logging is enabled.
max-request-re
tries
Maximum number of times to
retry AP-generated requests,
including keepalive messages.
After the maximum number of
retries, the AP either tries the
IP address specified by the
bkup-lms-ip (if configured) or
reboots.
1-65535 10
mtu
MTU, in bytes, on the wired link
for the AP.
1024-1578 —
native-vlan-id
Native VLAN for bridge mode
virtual APs (frames on the
native VLAN are not tagged
with 802.1q tags).
— 1
no
Negates any configured
parameter.
— —
number-ipsec-retries
The number of times the AP
will attempt to recreate an
IPsec tunnel with the master
controller before the AP will
reboot. A value of 0 disables
the reboot.
1-1000 85
rap-bw-total
This is the total reserved uplink
bandwidth (in Kilobits per
second).
— —
rap-bw-resv-1
Session ACLs with uplink
bandwidth reservation in
kilobits per second. You can
specify up to three session
ACLs to reserve uplink
bandwidth. The sum of the
three uplink bandwidths should
not exceed the rap-bw-total
value.
— —
rap-bw-resv-2
— —
rap-bw-resv-3
— —
Dell Networking W-Series ArubaOS 6.4.x | User Guide ap system-profile | 232