Users Guide

231 | ap system-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description Range Default
When using redundant
controllers as the LMS, set this
parameter to be the VRRP IP
address to ensure that APs
always have an active IP
address with which to
terminate sessions.
NOTE: If the LMS-IP is blank, the
access point will remain on the
controller that it finds using
methods like DNS or DHCP. If an
IP address is configured for the
LMS IP parameter, the AP will be
immediately redirected to the
controller at that address.
lms-ipv6
In multi-controller ipv6
networks, specifies the IPv6
address of the local
management switch (LMS)—
the controller—which is
responsible for terminating
user traffic from the APs, and
processing and forwarding the
traffic to the wired network.
This can be the IP address of
the local or master controller.
When using redundant
controllers as the LMS, set this
parameter to be the VRRP IP
address to ensure that APs
always have an active IP
address with which to
terminate sessions.
— —
lms-ping-interval
Specifies the interval at which
application level ping needs to
be sent to primary controller to
check the reachability. Applicable
only for RAP.
NOTE: If this parameter is
changed, UDP session timeout
on an intermediate router which
performs NATing should be set
accordingly. The preferred
timeout value is (lms-ping-
interval + 30sec).
10-60 seconds 20 seconds
lms-preemption
Automatically reverts to the
primary LMS IP address when
it becomes available.
— disabled
maintenance-
mode
Enable or disable AP
maintenance mode.
disabled