Users Guide

Parameter Description Range Default
ap-usb-power-override
Enabling override enables the
USB port of the AP with POE AT
power.
NOTE: This parameter is
applicable for W-AP205H access
point only.
— disabled
ip-or-dns
IP address or the DNS of the
AeroScout server to which
location reports are sent.
— —
port
Port number on the AeroScout
server to which location
reports are sent.
— —
bkup-band a|all|g
Band on which the controller
broadcasts the backup ESSID.
802.11a, all
bands or
802.11g
all
bkup-lms-ip
In multi-controller networks,
specifies the IP address of a
backup to the IP address
specified with the lms-ip
parameter.
— —
bkup-lms-ipv6
In multi-controller ipv6
networks, specifies the IPv6
address of a backup to the IPv6
address specified with the lms-
ipv6 parameter.
— —
bkup-mode
dynamic|off|static
This parameter allows AP
console access using a backup
ESSID, allowing users to access
an AP console after the AP has
disconnected from the
controller. When the AP
advertises a backup ESSID in
either static or dynamic mode,
a user is able to access and
debug the APremotely through
a virtual AP.
Select dynamic or static to
enable this feature and select
the mode by which the
controller broadcasts the
backup ESSID. This feature is
disabled by default.
dynamic|off|static off
bkup-password <bkup-pass-
word>
Allows client access to adjust the
band and mode settings for the
backup ESSID.
— —
ble-token
The Bluetooth Low Energy (BLE)
endpoint authorization token is a
— —
Dell Networking W-Series ArubaOS 6.4.x | User Guide ap system-profile | 228