Users Guide

Parameter Description Default
handover-trigger-profile
Name of the handover trigger profile associated with this
802.11k profile. If the handover trigger feature is enabled
in the handover trigger profile, the controller will initiate
the handover of a voice client (for example: dual mode
handsets) roaming at the edge of Wi-Fi coverage to an
alternate carrier or connection. The handover trigger is
initiated if the Wi-Fi signal strength reported by the voice
client (received from all APs) is equal to or less than the
threshold value.
You must enable dot11k before using this command.
lm-req-time
This option configures the time duration between two
consecutive link measurement requests sent to an dot11K
client. By default, link measurement requests are sent to a
dot11K client every 61 seconds. However, you can use the
lm-req-time option to specify different time interval.
This permits values in the range from 10 seconds to 200
seconds.
61
seconds
no
Negates or removes any configured parameter
rrm-ie-profile
RRM IE Settings Profile
tsm-req-profile
TSM Report Request Settings Profile
tsm-req-time
This option configures the time duration between two
consecutive transmit stream measurement requests sent
to a dot11K client. By default, the transmit stream
measurement requests are sent to a dot11K client every 90
seconds. However, you can use the tsm-req time option
to specify a different time interval.
This permits values in the range from 10 seconds to 200
seconds.
90
seconds
Usage Guidelines
In a 802.11k network, if the AP with the strongest signal is reaches its maximum capacity, clients may connect
to an under utilized AP with a weaker signal. A 802.11k profile can assigned to each virtual AP.
Example
The following command enables the 802.11k feature on the 802.11k profile and configures the beacon
measurement mode and specifies the time interval for beacon, link, and transmit stream measurement
requests.
(host) (config) #wlan dot11k-profile default
(host) (802.11K Profile "default") #dot11k-enable
(host) (802.11K Profile "default") #bcn-measurement-mode beacon-table
(host) (802.11K Profile "default") #bcn-req-time 60
(host) (802.11K Profile "default") #lm-req-time 60
(host) (802.11K Profile "default") #tsm-req-time 90
Dell Networking W-Series ArubaOS 6.4.x | User Guide wlan dot11k-profile | 2264