Users Guide

wlan dot11k-profile
wlan dotllk <profile-name>
ap-chan-rpt-11a
ap-chan-rpt-11bg
bcn-measurement-mode {active|beacon-table|passive}
bcn-req-chan-11a
bcn-req-chan-11bg
bcn-req-time
clone <profile-name>
dot11k-enable
force-disassoc
handover-trigger-profile
lm-req-time
no ...
rrm-ie-profile
tsm-req-profile
tsm-req-time
Description
Configure a 802.11k radio profile.
Syntax
Parameter Description Default
<profile-name>
Name of this instance of the profile. The name must be 1-
63 characters.
“default”
ap-chan-rpt-11a
This value is sent in the 'Channel' field of the AP channel
reports on the 'A' radio. You can specify values in the range
34 to 165.
36
ap-chan-rpt-11bg
This value is sent in the 'Channel' field of the AP channel
reports on the 'BG' radio. You can specify values in the
range 1 to 14.
1
bcn-measurement-mode
Configures an active, beacon-table or passive beacon
measurement mode for the profile.
beacon-
table
active
Enables active beacon measurement mode. In this mode,
the client sends a probe request to the broadcast
destination address on all supported channels, sets a
measurement duration timer, and, at the end of the
measurement duration, compiles all received beacons or
probe response with the requested SSID and BSSID into a
measurement report.
NOTE: If the station doesn't support active measurement
mode, it returns a Beacon Measurement Report with the
Incapable bit set in the Measurement Report Mode field.
—
Dell Networking W-Series ArubaOS 6.4.x | User Guide wlan dot11k-profile | 2262