Users Guide

217 | ap regulatory-domain-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
ap regulatory-domain-profile
ap regulatory-domain-profile <profile>
clone <profile>
country-code <code>
no ...
valid-11a-40mhz-channel-pair <valid-11a-40mhz-channel-pair>
valid-11a-80mhz-channel-group <valid-11a-80mhz-channel-group>
valid-11a-channel <num>
valid-11g-40mhz-channel-pair <valid-11g-40mhz-channel-pair>
valid-11g-channel <num>
Description
This command configures an AP regulatory domain profile.
Syntax
Parameter Description
Default
<profile>
Name of this instance of the profile. The name
must be 1-63 characters.
—
clone
Name of an existing regulatory domain profile
from which parameter values are copied.
—
country-code
Code that represents the country in which the
APs will operate. The country code determines
the 802.11 wireless transmission spectrum.
Improper country code assignment can disrupt
wireless transmissions. Most countries impose
penalties and sanctions for operators of wireless
networks with devices set to improper country
codes.
country code configured on
the master controller during
initial setup
no
Negates any configured parameter.
—
valid-11a-40mhz
-channel-pair
Specify a channel pair valid for 40 MHz
operation in the 802.11a frequency band for the
specified regulatory domain. The two channels
must be separated by a dash.
Example:
36-40
44-48
52-56
country code determines
supported channel pairs
Note: Changing the country
code causes the valid
channel lists to be reset to
the defaults for the country.
valid-11a-80mhz-
channel-group
This parameter defines which 80MHz channels on
the “a” band are available for assignment by ARM
and for controller to randomly assign if the user has
not specified a channel. The channel numbers
—