Users Guide

2043 | show whitelist-db rap-local-switch-list Dell Networking W-Series ArubaOS 6.4.x| User Guide
The output of this command includes the following information:
Parameter Description
Active
Shows if the controller is active on the network.
l 1: Active
l 0: Inactive
MAC-Address
MAC address of the local controller.
IP-Address
IP address of the local controller.
Sequence Number
The number of times the local controller in the whitelist received and
acknowledged a remote AP whitelist change from the master controller. In
the example above, both local controllers received and acknowledged three
remote AP whitelist changes sent from the master controller.
Remote Sequence Number
The number of times that the master controller has received and
acknowledged a remote AP whitelist change from the local controller in the
whitelist. In the example above, the master controller received and
acknowledged a single remote AP whitelist change from the local controller
with the MAC address 00:0b:86:51:a5:4c.
Null Update Count
The number of times the controller has checked its remote AP whitelist and
found nothing to synchronize with the remote controller. By default, the
controller compares its remote AP whitelist against whitelists on other
controllers every minute. If the null update count reaches 5, the controller
will send an “empty sync” heartbeat to the remote controller to ensure the
sequence numbers on both controllers are the same, then reset the null
update count to zero.
Related Commands
Command Description Mode
show whitelist-db rap-master-
switch-list
Delete a master controller from the master switch
table used by the remote AP whitelist
Config mode
whitelist-db rap del Remove an AP entry from the remote AP whitelist. Config mode
Command History
Version Modification
ArubaOS 6.3 Command introduced