Users Guide

20 | The ArubaOS Command-Line Interface Dell Networking W-Series ArubaOS 6.4.x| User Guide
Command Description
l allow-stun
l dpi
l stall-crash
ha The following parameters are introduced to support the high
availability inter-controller heartbeat, controller oversubscription
and state synchronization features.
l heartbeat:
l heartbeat-interval
l heartbeat-threshold
l over-subscription
l pre-shared-key
l state-sync
interface fastethernet |
gigabitethernet
The lldp parameter is introduced.
interface vlan The dhcp parameter for configuring dynamic host configuration
protocol for IPv6 is introduced.
interface tunnel Tunnel destination ipv6, tunnel mode gre ipv6, tunnel source
ipv6, parameters are introduced.
ip access-list session The redirect parameter is introduced under action. The app, and
appcategory parameters are introduced under service.
ip igmp The ssm-range parameter is introduced.
ipv6 mld The ssm-range parameter is introduced.
ipv6 route The vlan parameter is introduced.
ntp server The IPv6 parameter is introduced.
show aaa authentication-server
radius
The called-station-id parameter is introduced as part of this
command output.
show airgroup The dlna and mdns parameters are introduced as part of the
following command outputs:
l show airgroup blocked-queries
l show airgroup blocked-service-id
l show airgroup internal-state statistics
The dlna, mdns , and verbose parameters are introduced as part
of the following command outputs: