Users Guide

1837 | show rf arm-profile Dell Networking W-Series ArubaOS 6.4.x| User Guide
Scanning Enabled
Multi Band Scan Enabled
VoIP Aware Scan Enabled
Power Save Aware Scan Disabled
Video Aware Scan Enabled
Ideal Coverage Index 10
Acceptable Coverage Index 4
Free Channel Index 25
Backoff Time 240 sec
Error Rate Threshold 50 %
Error Rate Wait Time 30 sec
Channel Quality Aware Arm Disabled
Channel Quality Threshold 70 %
Channel Quality Wait Time 120 sec
Minimum Scan Time 8
Load aware Scan Threshold 1250000 Bps
Mode Aware Arm Disabled
Scan Mode all-reg-domain
Client Match Enabled
Client Match report interval (sec) 30
Client Match Unsteerable Client Ageout Enabled
Client Match Unsteerable Client Ageout Interval 2 0
Client Match Sticky Client Check Interval (sec) 3
Client Match Sticky client check SNR (dB) 25
Client Match SNR threshold(dB) 99
Client Match Sticky Min Signal 70
Client Match Restriction timeout (sec) 255
Client Match Load Balancing threshold (%) 20
Client Match VBR Stale Entry Age (sec) 120
Client Match Max steer failures 5
Client Match Load Balancing client threshold 10
Client Match Load Balancing SNR threshold (dB) 77
The output of this command includes the following parameters:
Parameter Description
Assignment Displays the current ARM channel/power assignment mode.
Allowed bands for 40MHz
channels
Shows if 40 MHz mode of operation is allowed on the 5 GHz (802.11a)
or 2.4 GHz (802.11b/g) frequency band only, on all frequency bands, or
on neither frequency band.
Client Aware Shows if the client aware feature is enabled or disabled. When
enabled, the AP does not change channels when there are active
clients.
Max Tx Power The highest transmit power levels for the AP, from 0-30 dBm in 3 dBm
increments. Higher power level settings may be constrained by local
regulatory requirements and AP capabilities. In the event that an AP is
configured for a Max Tx Power setting it cannot support, this value will
be reduced to the highest supported power setting.
Min Tx Power The lowest transmit power levels for the AP, from 0-30 dBm, in 3 dBm
increments. Note that power settings will not change if the Assignment
option is set to disabled or maintain.