Users Guide
1587 | show ip health-check Dell Networking W-Series ArubaOS 6.4.x| User Guide
show ip health-check
Description
Display the health-check status of the uplink interfaces of a branch-office controller.
Syntax
No parameters.
Example
The following example displays the status of two uplinks on a branch controller.
(host) #show ip health-check
IP Health-Check Entries
-----------------------
Probe IP Src Interface State Probe Profile Avg RTT(ms)
-------- ------------- ------ -------------- ----------
10.10.10.254 vlan 1 UP Default 20.4
10.10.10.254 Cellular DOWN Default 0
The output of this command includes the following data columns.
Parameter Description
Probe IP
IP address of the master controller.
Src Interface
IP address of the uplink gateway interface through which the probes were
sent.
State
Shows if the uplink is in an UP or DOWNstate.
Probe-Profile
A branch controller supports only the default IP probe profile. For inform-
ation on configuring an IP probe profile, see ip probe
Avt RTT (in ms)
The average round trip time, in milliseconds. If the round trip time is less
than 1 millisecond, the average round trip time will appear as 0.
Related Commands
Command Description
ip probe This command configures WAN health-check ping-probes for measuring
WAN availability and latency on branch controller uplinks.
show ip probe This command displays the settings for the WAN health-check ping-probes.