Users Guide

Parameter Description
Multicast automatic shaping
If enabled, enables multicast optimization and
provides excellent streaming quality regardless
of the amount of VLANs or IP IGMP groups that
are used.
Stall Detection
If enabled, triggers datapath crash on stall
detection. Applies to the to W-7200
Seriescontrollers only.
Enforce TCP Sequence numbers
If enabled, prevents data from passing between
two clients until the three-way TCP handshake
has been performed.
AMSDU Rx
Aggregated Medium Access Control Service
Data Units (AMSDU) packets are dropped if this
option is enabled.
Jumbo Frames
If enabled, supports up to 9216 bytes of payload
on the controller.
Session-tunnel FIB
Enables session tunnel based forwarding.
Prevent DHCPExhaustion
If enabled, this option checks for DHCP client
hardware address against the packet source
MAC address. This command checks the frame's
source-MAC against the DHCPv4 client hardware
address and drops the packet if it does not
match. This feature prevents a client from
submitting multiple DHCP requests with different
hardware addresses, thereby preventing DHCP
pool depletion.
Stateful SIPS Processing
If disabled, disables monitoring of exchanges
between a voice over IP or voice over WLAN
device and a SIP server. This option should be
enabled only when there is no VoIP or VoWLAN
traffic on the network.
Deny Source Routing
If enabled, forwarding of IP frames with source
routing with the source routing options set is
disallowed.
Immediate Freeback
If enabled, immediately frees buffers on W-
7200controllers. Do not enable this option unless
instructed to do so by a technical support
representative.
DPI Classification
If enabled, performs deep packet inspection.
STUN Based Traversal
If enabled, allows STUN- based firewall traversal.
Web Content Classification
If enabled, allows web content classification for
all HTTP traffic.
Dell Networking W-Series ArubaOS 6.4.x | User Guide show firewall | 1480