Users Guide

1479 | show firewall Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
Stateful H.323 Processing
Shows if the controller has enabled or disabled
stateful H.323 processing.
Stateful SCCP Processing
Shows if the controller has enabled or disabled
stateful SCCP processing.
Only allow local subnets in user table
If enabled, the controller only adds IP addresses
which belong to a local subnet to the user table.
Monitor/police CP attacks
If enabled, the controller monitors a misbehaving
user’s inbound traffic rate. If this rate is
exceeded, the controller can register a denial of
service attack.
Rate limit CP untrusted ucast traffic
Shows the inbound traffic rate
Rate limit CP untrusted mcast traffic
Displays the untrusted multicast traffic rate limit.
Rate limit CP trusted ucast traffic
Displays the trusted unicast traffic rate limit.
Rate limit CP trusted mcast traffic
Displays the trusted multicast traffic rate limit.
Rate limit CP route traffic
Displays the traffic rate limit for traffic that
needs generated ARP requests.
Rate limit CP session mirror traffic
Displays the traffic rate limit for session
mirrored traffic forwarded to the controller.
Rate limit CP auth process traffic
Displays the traffic rate limit for traffic forwarded
to the authentication process.
Deny inter user traffic
If enabled, this setting disables traffic between
all untrused users. You can configure user role
policies that prevent Layer-3 traffic between
users or networks but this does not block Layer-2
traffic.
Prohibit ARP Spoofing
When this option is enabled, possible arp
spoofing attacks are logged and an SNMP trap is
sent.
Stateful VOCERA Processing
VOCERA processing is disabled by default.
Stateful UA Processing
UA processing is disabled by default.
Enforce bw contracts for broadcast traffic
If enabled, bw contracts are applied ot local
subnet broadcast traffic.