Users Guide

1437 | show datapath Dell Networking W-Series ArubaOS 6.4.x| User Guide
WEP No Key (not serious) 0
TKIP Encryptions 0
TKIP Encryption Failures 0
TKIP Decryptions 0
TKIP Decryption Failures 0
TKIP MIC Failures 0
TKIP Decrypt Bad Counter 0
TKIP P1Key Not Ready 0
...
The following parameters appear in the output of the show datapath crypto counters command, and are
useful for debugging purposes.
Parameter Description
Crypto BadNPlus
Indicates a queue overrun in the output of the encryption circuit.
Crypto SendNPlusFailed
Indicates a queue overrun in the input of the encryption circuit.
IPSec Frag Failures
This counter increments when the AP detects a failure to fragment a frame
before or after IPsec encryption.
IPSec Invalid Length
The inbound IPsec frame length is verified before and after decryption. If the
frame length is found to be incorrect , this counter is incremented.
IKE Rate
When the controller firewall receives a UDP packet, it determines if the packet
is destined for an IKE (500) or IPSEC_NATT (4500) port. This counter incre-
ments when the AP receives an initial IKE packet that has an 8-byte responder
cookie defined all 0s.
Example of the show datapath compression command output
+----+------+-----------------------------------------------------+
|SUM/| | | |
|CPU | Addr | Description Value |
+----+------+-----------------------------------------------------+
| | [00] | Compression Engine Present True |
| | [01] | Comp Response received 150 |
| | [02] | Comp Response failed 0 |
| | [03] | Decomp Requests 80 |
| | [04] | Decomp Response received 80 |
| | [05] | Decomp Requests queued 75 |
| G | [06] | Compression Engine Total 4 |
+----+------+-----------------------------------------------------+
The following output displays the