Users Guide

1425 | show datapath Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
multicast traffic generated by the controller(2).
l Cont ID: An ID number unique to each contract.
l Rate: Contract traffic rate, in 256-byte packets/second.
l Policed: The number of packets dropped because the policy was
applied.
l Avail Credits: This value is the (contract rate)/32, and is used for
internal debugging purposes.
l Queued Pkts/ Bytes: Number of bytes/pkts currently being
queued.
l Flags: Flags applied to the contract.
l CPU: A value in this column indicates that the traffic passed
through the slowpath CPU, and is used for internal debugging
purposes.
l Status: Indicates whether the bandwidth contract has been
successfully applied.
ap-name
<ap-name>
View a bandwidth contract for a specific AP.
ip-addr
<ip-addr>
View a bandwidth contract for an AP with the specified IP address.
table
Display a table of all configured bandwidth contracts.
type
Display only bandwidth contracts of a specific type (0,1 or 2).
compression
Displays datapath compression statistics. By default, the combined
statistics of all CPUs are shown.
cp-bwm
Displays the data path CP bandwidth management table
information.
crypto counters
Displays crypto parameter statistics including crypto, IPsec, PPTP,
WEP, TKIP, AESCCM encryption and decryptions, WEP CRC, crypto
hardware, XSEC, DOT1X, and L2TP information.
debug
Displays datapath debug details. These are low-level datapath
details.
dma counters
DMA statistics are displayed.
eap counters
EAP termination statistics are displayed.
eth1info
Displays IPv4 fragment table statistics.
memory
Displays SOS memory statistics.
opcode
Displays datapath debugging information.