Users Guide

show country
show country [trail]
Description
Show controller’s country and domain upgrade trail.
Syntax
Parameter Description
trail
Display the record showing how the switch was reconfigured for it’s current
country domain when the controller hardware was upgraded.
Usage Guidelines
A controller’s country code sets the regulatory domain for the radio frequencies that the APs use. This value is
typically set during the controller’s initial setup procedure. Use this command to determine the country code
specified during setup.
Example
The output of this command shows the controller’s country, model and hardware types.
(host) # show country
Country:US
Model:DellW-650-US
Hardware:Restricted US
Command History
This command was available in ArubaOS 1.0.
Command Information
Platforms
Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide show country | 1396