Users Guide

Command Description
firewall l The web-cc parameter is introduced. This parameter enables web
content classification for all HTTP traffic. Once enabled, ArubaOS
enforces ACLs and bandwidth policies associated with web content
categories or reputation levels.
l The web-cc-cache-miss-drop parameter is introduced. Issue this
command to allow the controller to drop any packets that do not
match any web content category or reputation levels in the
controller's internal web content cache.
ip access-list session The web-cc-category and web-cc-reputation parameters are
introduced. Use these parameters to define a session ACL for traffic
matching a web content category or reputation level.
provision-ap The service-tag parameter was introduced under reprovision
parameter.
rf dot11g-radio-profile The very-high-throughput-rates-enable parameter is introduced.
This command enables very high throughput (VHT) rates on the 2.4
GHz band through the addition of VHT Modulation and Coding
Scheme values 8 and 9, providing 256-QAM modulation and encoding
that allows for 600 Mbit/sec performance over 802.11n networks. VHT
rates are supported on W-AP220 Series access points on both 20 and
40 MHz channels.
show ap database The output of this command can display:
l an s flag to indicate that the AP is enabled with a striping IP
address.
l the service tag of an AP.
show ap debug lacp If a GRE striping IP address is configured in the ap-lacp-striping-ip
profile, the output of this command displays the GRE striping IP
address.
show ap debug system-
status
The format of the System Status Script output is changed to the
following:
function-name(line-num): new-total-drops/total-drops new-
priority-drops/total-priority-drops
Example: wlc_dotxstatus(40576): 5034/3231117 4272/1907873
This change helps to determine if priority (voice or video)frames are
dropped from the AP Wi-Fi driver drop-list.
NOTE: The System Status Script is displayed for W-AP200 Series and
W-AP220 Series access points only.
show ap details The output of this command can display the service tag of an AP.
show datapath l The session web-cc parameter is introduced. This command
displays web-content category information about the session.
l The web-cc parameter is introduced. This command parameter
displays web-content classification table information, including the
Dell Networking W-Series ArubaOS 6.4.x | User Guide The ArubaOS Command-Line Interface | 13