Users Guide

1223 | show ap monitor debug Dell Networking W-Series ArubaOS 6.4.x| User Guide
Column Description
l m-point: AP is configured as a Mesh point.
task
This parameter displays one of the following options to show the radio’s
current task:
l scan: AP is scanning other channels.
l tuned: AP is tuned on one channel.
l locate: AP has been asked to locate a specific AP or client.
l pcap: The AP is enabled with the Packet Capture feature.
channel
The radio channel currently used by an AP’s WLAN interface.
pkts
Number of packets seen on the interface.
mac
MAC address for the AP’s wired interface.
ip
The AP’s IP address.
gw-ip
IP address for the AP’s gateway.
gw-mac
MAC address for the AP’s gateway.
status
Shows if the interface is currently enabled or disabled.
pkts
Number of packets seen on the AP’s wired interface.
macs
Number of MAC addresses in the Wired MAC table for that interface.
gw-macs
Number of MAC addresses in the Wired MAC table for that interface.
tagged-pkts
Number VLAN-tagged packets sent to that interface.
vlan
The VLAN ID for the packets sent to that interface.
Packets read
Number of packets read by the AP since it was last reset.
Bytes read
Number of bytes read by the AP since it was last reset.
Num Intercepts
Number of interrupts from the AP’s driver.
Num Buffer Overflows
Number of times excessive traffic has filled the AP’s buffers.
Max PPS
Maximum throughput rate seen on the interface, in packets per second.
Cur PPS
Current throughput rate seen on the interface, in packets per second.