Users Guide

show ap mesh debug meshd-log
show ap mesh debug meshd-log {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>} [<page>]
Description
Show the debug log messages for the meshd process.
Syntax
Parameter Description
ap-name <ap-name>
Show data for an AP with a specific name.
bssid <bssid>
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The
Basic Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr>
Show data for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
<page>
Display page number 0, 1 or 2, where page 0 has the newest information and
page 2 has the oldest. If this parameter is omitted, this command will display
all meshd log information, oldest first.
Usage Guidelines
This is an internal technical support command. Dell technical support may request that you issue this
command to help analyze and troubleshoot problems with the meshd process or your mesh network.
Command History
Release Modification
ArubaOS 3.0 Command introduced.
ArubaOS 3.4 The page parameter was introduced.
Command Information
Platforms Licensing Command Mode
All platforms This show command is
available in the base
operating system.
Commands to configure the
mesh feature require the
Mesh license.
Enable or Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide show ap mesh debug meshd-log | 1196