Users Guide

Parameter Description
802.11g Beacon Rate
Sets the beacon rate for
802.11g for APs use a
Distributed Antenna
System (DAS). Using this
parameter in normal
operation may cause
connectivity problems.
802.11a Beacon Rate
Sets the beacon rate for
802.11a for APs use a
Distributed Antenna
System (DAS). Using this
parameter in normal
operation may cause
connectivity problems.
Advertise QBSS Load IE
Shows if the AP has
enabled or disabled the
advertising of QBSS in the
load IE.
High throughput enable (SSID)
Shows if the AP has
enabled or disabled the
use of its high-throughput
SSID in 40 MHz mode.
40 MHz channel usage
Determines if this high-
throughput SSID allows
high-throughput (802.11n)
stations to associate.
MPDU Aggregation
Shows if the AP has
enabled or disabled MAC
protocol data unit (MDPU)
aggregation.
Max transmitted A-MPDU size
Shows the maximum size,
in bytes, of an A-MPDU
that can be sent on the
AP’s high-throughput SSID.
Max received A-MPDU size
Shows the maximum size,
in bytes, of an
Aggregated-MAC Packet
Data Unit (A-MPDU) that
can be received on the
AP’s high-throughput SSID.
Min MPDU start spacing
Displays the minimum
time between the start of
adjacent MDPUs within an
aggregate MDPU, in
microseconds.
Dell Networking W-Series ArubaOS 6.4.x | User Guide show ap config | 1046