Users Guide

Parameter Description
Maximum Distance
Maximum distance
between a client and an
AP or between a mesh
point and a mesh portal, in
meters. This value is used
to derive ACK and CTS
timeout times. A value of 0
specifies default settings
for this parameter, where
timeouts are only
modified for outdoor
mesh radios which use a
distance of 16km.
The upper limit for this
parameter varies,
depending on the 20/40
MHz mode for a 2.4GHz
frequency band radio:
l 20MHz mode: 54km
l 40MHz mode: 24km
Iff you configure a value
above the supported
maximum, the maximum
supported value will be
used instead. Values
below 600m will use
default settings.
Spectrum Monitoring
When this parameter is
enabled, it turns an AP in
ap-mode into a hybrid AP.
An AP in hybrid AP mode
will continue to serve
clients as an access point
while it scans and
analyzes spectrum
analysis data for a single
radio channel.
Assignment
Displays whether or not
ARM channel and power
assignment has been
enabled or disabled.
Allowed bands for 40MHz channels
Forty MHz channels may
be used on the specified
radio bands (802.11a or
802.11g).
Client Aware
Shows if the client aware
feature has been enabled
or disabled for this AP. If
enabled, AP will not
change channels when
there are active clients.
Dell Networking W-Series ArubaOS 6.4.x | User Guide show ap config | 1036