Users Guide

1029 | show ap config Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
Remote-AP DHCP Server Id
Shows the IP Address of
the DHCP DNS Server.
Remote-AP DHCP Default Router
Shows the IP Address of
the DHCP Default Router.
Remote-AP DHCP Pool Start
Shows the IP Address
used as start of DHCP
Pool.
Remote-AP DHCP Pool End
Shows the IP Address
used as end of DHCP Pool.
Remote-AP DHCP Pool Netmask
Shows the netmask of
DHCP Pool.
Remote-AP DHCP Lease Time
Shows the length of
leases, in days (0 means
infinite).
Remote-AP uplink total bandwidth
This is the total reserved
uplink bandwidth (in
Kilobits per second)
Remote-AP bw reservation
Session ACLs with uplink
bandwidth reservation in
kilobits per second. You
can specify up to three
session ACLs to reserve
uplink bandwidth.
Heartbeat DSCP
DSCP value of AP
heartbeats (0-63).
Session ACL
Shows the access control
list (ACL) applied on the
uplink of a remote AP.
Maintenance Mode
Shows if Maintenance
mode is enabled or
disabled. If enabled, APs
stop flooding unnecessary
traps and syslog
messages to network
management systems or
network operations
centers when deploying,
maintaining, or upgrading
the network. The
controller still generates
debug syslog messages if
debug logging is enabled.