Users Guide

6. (Optional) If you enabled the Uplink Health-Check feature in step 4, you can use the HealthCheck
Settings parameters to modify the health-check ping probe settings described in the table below.
7. Click Apply.
Parameter Description
Probe Mode
Click the Probe Mode drop-down list and select ping to enable this feature.
Probe Interval (sec)
The Probe Interval field specifies the probe interval, in seconds. The WAN health-
check feature sends the number of probes defined by the Pocket Burst per Probe
parameter during each probe interval. To change the default interval of 10 seconds,
enter a new value into this field.
PacketBurst Per Probe
The Pocket Burst per Probe field specifies the number of probes to be sent during
the probe interval. To change the default value of 5 probes, enter a new value into this
field.
Probe Retries
The number of times the controllerattempts to resend a probe.
Table 209: WAN Health Check Settings
In the CLI
(host) (config) #uplink enable
(host) (config) #uplink wired priority 200
(host) (config) #uplink cellular priority 100
(host) (config) #uplink health-check enable
(host) (config) #uplink health-check ip '192.0.2.2'
Dell Networking W-Series ArubaOS 6.5.x | User Guide Adding Local Controllers | 917