Users Guide

Table Of Contents
833| Management Access Dell Networking W-Series ArubaOS 6.5.x| User Guide
In the above command, <session-timeout> can be any number of seconds from 30 to 3600, inclusive.
In the CLI
To define a timeout interval for a CLI session, use the command:
(host)(config) #loginsession timeout <value>
In the above command, <val> can be any number of minutes from 5 to 60 or seconds from 1 to 3600,
inclusive. You can also specify a timeout value of 0 to disable CLI session timeouts.
Connecting to an W-AirWave Server
W-AirWave is a powerful and easy-to-use network operations system that manages Dell W-Series wireless,
wired and remote access networks, as well as wireless and wired infrastructures from Dell and a wide range of
third-party manufacturers.
Controllers running ArubaOS 6.3 and later can use the W-AirWave wizard in the Configuration > Wizards >
W-AirWave section of the controller WebUI to quickly and easily connect the controller to an W-AirWave
server. The following checklist lists the information you will need to use this wizard. Determine each of these
values for your deployment and W-AirWave server before you start the wizard process.
Information Description My Values
W-AirWave
IPaddress
IP address of the W-AirWave server.
SNMP version Specify if the controller and W-AirWave serer should communicate
using SNMP v2 or SNMPv3. SNMPv3 communications between a
controller and an W-AirWave server use SHAauthentication and
AES encryption.
For SNMPv2 If you select SNMPv2, you must enter an SNMP community string.
Table 180: W-AirWave Wizard Checklist