Users Guide

703| Remote Access Points Dell Networking W-Series ArubaOS 6.5.x| User Guide
a. Make sure Virtual AP enable is selected.
b. From the VLAN drop-down menu, select the VLAN ID to use for the Virtual AP profile.
c. From the Forward mode drop-down menu, select bridge.
d. From the Remote-AP Operation drop-down menu, select always or backup.
e. Click Apply.
7. Under Profiles, select AP, then AP system profile.
8. Under Profile Details, do the following:
a. Select the AP system profile to edit.
b. At the LMS IP field, enter the LMS IP address.
c. At the Master controller IP address field, enter the master controller IP address.
d. Configure the Remote-AP DHCP Server fields.
e. Click Apply.
In the CLI
Use the following commands:
(host) (config) #wlan ssid-profile <profile>
essid <name>
opmode <method>
wpa-passphrase <string> (if necessary)
(host) (config) #wlan virtual-ap <name>
ssid-profile <profile>
vlan <vlan>
forward-mode bridge
aaa-profile <name>
rap-operation {always|backup}
(host) (config) #ap system-profile <name>
lms-ip <ipaddr>
master-ip <ipaddr>
rap-dhcp-default-router <ipaddr>
rap-dhcp-dns-server <ipaddr>
rap-dhcp-lease <days>
rap-dhcp-pool-end <ipaddr>
rap-dhacp-pool-netmask <netmask>
rap-dhcp-pool-start <ipaddr>
rap-dhcp-server-id <ipaddr>
rap-dhcp-server-vlan <vlan>
(host) (config) #ap-group <name>
virtual-ap <name>
ap-system-profile <name>
or
(host) (config) #ap-name <name>
virtual-ap <name>
ap-system-profile <name>
Specifying the DNS Controller Setting
In addition to specifying IP addresses for controllers, you can also specify the master DNS name for the
controller when provisioning the remote AP. The name must be resolved to an IP address when attempting to
set up the IPSec tunnel. For information on how to configure a host name entry on the DNS server, refer to the