Users Guide

691| Remote Access Points Dell Networking W-Series ArubaOS 6.5.x| User Guide
Summary
Table Name
Basic View Information Advanced View Information
Uplink Info The Uplink Info table can display some
or all of the following information for
your remote AP, depending upon
whether a link is active and the number
of links supported by the AP.
Active uplink information, including:
l Interface name
l Port speed
l IP address
Standby link information, including:
l Name (3G)
l Device connected (yes/no)
l Provisioned (yes/no)
l IP address
l Device
l User
l Password
N/A
Multihoming on remote AP (RAP)
You can uplink a RAP as an Ethernet or a USB based modem. These uplinks can be used as a backup link if the
primary link fails. The uplink becomes active based on the order of priority configured on the RAP. The RAP
switches back to the primary link when the primary connection is restored.
For information on provisioning the RAP using the USB based modem, see Provisioning 4G USB Modems on
Remote Access Points on page 719.
Seamless failover from backup link to primary link on RAP
RAPs can failover from a backup link to a primary link without much disruption to traffic. Also the failover is
performed only if the controller is reachable via the primary link.
Remote AP Connectivity
The information shown on the Connectivity tab will vary, depending upon the current status of the remote
AP. If a remote AP has been successfully provisioned and connected, it should display some or all of the
information in Table 149.