Users Guide

You can use all the special characters except question mark (?) and the space can be used within double quotes (“ “).
4. Enter the CHAP Secret again in the Confirm CHAP Secret text box for confirmation.
Figure 93 CHAP Authentication Using CHAP Secret
5. Click Apply and Reboot.
In the CLI
(host) (config) #provision-ap pppoe-chap-secret <KEY>
reprovision ap-name <name>
Configuring Certificate RAP
You can configure the remote AP to use the internal certificate for authentication. You can use the WebUI or
CLI to configure the certificate RAP.
In the WebUI
1. Navigate to Configuration > AP Installation (under Wireless.)
2. Select the required remote AP under the Provisioning tab and then click Provision.
3. Select Yes for Remote AP and Certificate for Remote AP Authentication Method.
4. Click Apply and Reboot to apply the configuration and reboot the AP as certificate RAP.
In the CLI
(host) (config) #local-userdb-ap whitelist-db rap add <mac-address>
Creating a Remote AP Whitelist
If you use the Zero Touch provisioning method to provision the certificate RAP, then you must create a remote
AP whitelist. For more information on Zero Touch Provisioning of the RAP, see Provisioning 4G USB Modems
on Remote Access Points on page 719.
Remote AP whitelist is the list of approved APs that can be provisioned on your controller.
In the WebUI
1. Navigate to Configuration > AP Installation (under Wireless) and then click the RAP Whitelist tab on the
right side.
2. Click New and provide the following details:
l AP MAC Address—mandatory parameter. Enter the MAC address of the AP.
l Username—enter a username that is used when the AP is provisioned.
l AP Group—select a group to add the AP.
Dell Networking W-Series ArubaOS 6.5.x | User Guide Remote Access Points | 682